Tweet
Been trying to research how to cross wire my lincoln spool gun (magnum sg) into my millermatic 252? not sure if its possible just wondering if anyone else here has attempted this. i do have the miller male connector end with pins. there is 6 wires on the spool gun end. Thanks, Garrett
-
-
We have a couple of guys wanting to do the exact opposite....you fellas ought to trade!
www.facebook.com/outbackaluminumwelding
Miller Dynasty 700...OH YEA BABY!!
MM 350P...PULSE SPRAYIN' MONSTER
Miller Dynasty 280 with AC independent expansion card
Miller Dynasty 200 DX "Blue Lightning"
Miller Bobcat 225 NT (what I began my present Biz with!)
Miller 30-A Spoolgun
Miller WC-115-A
Miller Spectrum 300
Miller 225 Thunderbolt (my first machine bought new 1980)
Miller Digital Elite Titanium 9400
-
That's got to be the worst spool gun made. Sorry...BobBob WrightComment
-
I don't think it's possible. You need at least 7 wires. Your spool gun only has 2 wires for the potentiometer.Comment
-
right on bob thanks for the info,Comment
-
yes only 6 visible, i will cut further down and see if any wires broke off insideComment
-
Yes, only 6 wires. I don't know how that works with the pot. Can you make it work somehow? Probably but it might take a bit of hacking, is it even worth it? Probably better off just looking for a deal on a used spoolmatic 30a.Originally posted by 1997CST View Post
I'm not familiar with the mm252 but if you can set it so that the wire feed speed is controlled at the machine rather then by the gun pot, then you just need to connect the motor drive wires and gun trigger wires to the machine.www.silvercreekwelding.com
Miller Trailblazer 325 efi
Miller extreme 12vs
Thermal arc 186 ac/dc
Lincoln power wave 455m/stt with 10m dual feederComment
-
Separate plugs for the mig gun and spool gun. Can't set the speed on the machine.Originally posted by Willvis View PostComment
Comment