If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a 2014 pipepro 350. Has 290 hours. Having trouble starting ( takes 8-10 seconds ). Also having issues when transitioning from low idle to high when starting rods at high amperage.(usually takes 2-4 seconds ) .when machine finally gets up to high idle it runs and welds great. If anyone could give me any ideas as to what the cause is I sure would appreciate it. Thank u.