Dynasty 200dx help 01

[welderboyjk]

There was a glimmer of joy but not enough. After doing a reset it would stay on without coding in stick mode. As soon as the preflow timer was done in tig it would code.
I'll be calling tomorrow.

[H80N]

I'll try that this evening. Have my fingers crossed that's it's something easy!

If No Joy from the reset tonight.... call

Miller TIG Support - 920-735-4356 or 1-800-4-A-Miller (1-800-426-4553)

[welderboyjk]

I'll try that this evening. Have my fingers crossed that's it's something easy!

[H80N]

No I have not. Does that occasionally help?

Can't hurt

See Section 5-18

[welderboyjk]

No I have not. Does that occasionally help?

[H80N]

I have a Dynasty 200 that was running along happily about 140 amps dc and suddenly quit. Help 01 was displayed. Turning off the machine and restarting it doesn't help. From what I read this is going to be expensive but I was hoping there may be a glitch that is easily fixed. There were no funny smells, smoke or odd behavior. It just died. Unhooking everything, turning it on and setting the output to stick and the contactor to on throws it into help 1 as soon as the output turns on. I know it an older machine but I bought it when it was almost new with under 1 hr on the clock.
The specifics are;
S#LH140065L
Hours 16h 18m
Arc starts 11,500 or so
Software 221 136
Again, I don't see anything obviously scorched and there aren't any burnt electronic smells.
Pics to follow....

Manual

https://www.millerwelds.com/files/owners-manuals/O2240P_MIL.pdf

Have you done a reset to factory defaults...???

[welderboyjk]

Anyone have any pointers please?

[welderboyjk]

[welderboyjk]

I have a Dynasty 200 that was running along happily about 140 amps dc and suddenly quit. Help 01 was displayed. Turning off the machine and restarting it doesn't help. From what I read this is going to be expensive but I was hoping there may be a glitch that is easily fixed. There were no funny smells, smoke or odd behavior. It just died. Unhooking everything, turning it on and setting the output to stick and the contactor to on throws it into help 1 as soon as the output turns on. I know it an older machine but I bought it when it was almost new with under 1 hr on the clock.
The specifics are;
S#LH140065L
Hours 16h 18m
Arc starts 11,500 or so
Software 221 136
Again, I don't see anything obviously scorched and there aren't any burnt electronic smells.
Pics to follow....