If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a 400d cc/cv the problem I have is the welder is under a load as soon as it starts. I and turn the knob with no change. The ac plug only read around 60v Thanks for any suggestions
sorry for the delay had a family emergency come up..... The ser# is MD300045E I checked the 3 diodes in the white box and they checked good is there others?
Tweet
Comment