What gun for M30E Millermatic wire feeder

[duaneb55]

Looks complete to me.

My son has the MM30A with the power pin and block with a Tweco gun.

[knied1]

Tweco #2541-2051 should be the pin and block...Bob
http://www.ebay.com/itm/TWECO-TMSAK-...gAAOSwPc9Wzj4q

just to be clear.....this kit is all I need to adapt the wire feeder to a Tweco gun?


Thanks

[aametalmaster]

Don't forget to check your drive roll size. They could be from tiny to 1/8 wire dia. And i do sell skids full of Hobart 1/8" mig wire so it is used alot...Bob

[aametalmaster]

Tweco #2541-2051 should be the pin and block...Bob

http://www.ebay.com/itm/TWECO-TMSAK-35-WIRE-FEEDER-ADAPTER-TMSAK35-2541-2051-/370511225830?hash=item564430a3e6:g:1KgAAOSwPc9Wzj4q

[aametalmaster]

The power pin for the welder is Tweco TMSAK-352 http://www.ebay.com/itm/TWECO-WIRE-F...-/310692020005 Then you will need the adaptor block for the gun to the power pin. The adaptor block has a gas hose hook up...Bob

[knied1]

It doesn't matter to me if I have a miller or Tweco gun,
do you know what part number the Tweco adaptor is?

Thank you for looking into it for me

[aametalmaster]

I looked high up on a shelf at a feeder. Different number than yours but it also has a Tweco adaptor. But the adaptor only fits a Tweco gun. It also has a gas hose hook up where the gun plugs in. Wonder if i could drill a gas hole in yours and add a hose barb? I do have a machine shop also...Bob

[knied1]

I am trying to get the photos to upload full size...sorry for multiple posts

[knied1]

[knied1]

Bob,

no there isn't a hole or the gas. I am planning to use for standard home work shop type of thing...so I believe a 200 amp gun should suit my needs.

also do you know why the guy I bought this from added this box and remote gas connection?

Thank you

[Aeronca41]

Bob-just a note of thanks. Many people are benefitting from your new job not to mention your years of experience.

[aametalmaster]

Look inside where the gun plugs in and see if there is a hole for the gas...Bob

[aametalmaster]

His had an old Tweco gun with a square Tweco adaptor block where the gun plugged in and the gas went into the side of the adaptor block. I removed the adaptor block and plugged in a Bernard gun with a Miller pin. There was a hose nub sticking out of the backside where the gun plugged in for the gas hose. I prob have the same feeder on a shelf but I can't see it until Monday...Bob

[aametalmaster]

Found a manual. https://www.millerwelds.com/files/ow...O1235A_MIL.pdf
I helped a shop set up one of those old feeders yesterday. I ordered in a Miller gun but he was running huge wire. Any current Miller gun will fit it. What are you welding for gun size?..Bob

[aametalmaster]

Well that SN doesn't work and the pics are too small to see anything. For me anyways...Bob