Syncrowave 250 Gas solenoid elbows

[Crocket]

Does anyone here know a source for the brass elbows that at typically found on each side of the gas solenoid on older Sync 250s? My welder is missing both elbows. Up to this point I have been using a torch with a gas valve so it hasn't not been an issue but I'm now rigging up my water cooler and a ck20 so I need to use the solenoid.

My local shop quoted me right at $90 each, which shocked me for no more than what they are. I've searched the web but can't seem to find any. Does anyone here have any idea of a reasonably priced source for these?

[aametalmaster]

Look here...Bob http://www.mcmaster.com/#

[duaneb55]

. . . or here:

http://miller4less.com/advanced_search_result.php?keywords=010296&osCsid=2cddf1f2afefd0cb87d36f6855fb0d6b&search.x=10&search.y=7

[Crocket]

I looked around on McMasters site and didn't see one that matched the sizes however, I may have missed it. I'm not sure how I missed them on Miller4less, searched that site for a while and never saw them. I was going to order from miller4less but with the "small order fee" it put one elbow up to almost $50. I found one on ebay for $12 and snatched it up, I think I may just get a NPT barb fitting for the other side of the solenoid and use a hose clamp.

Thanks again guys!

[Meltedmetal]

Could you use something like this with a pipe elbow or is the 5/8 part the wrong s-e-x.

http://www.ebay.com/itm/5-8-18-RH-x-1-4-Male-Pipe-Mig-Welding-Gas-Fitting-Argon-Inert-Gas-Tig-Welder-/252436698889?hash=item3ac6665709:g:CBAAAOSwOVpXbUga