Welding on Drums & Tanks

[Farmer Boy]

I know it will not weld, but I know so many use a torch to cut the head off of drums,

and they sell caster bases or drum dolly,
and they do not look that hard to make as well one could jsut cross to flats and bend up the edges at a 90 to keep the drum centered, or if one has a ring roller roll the ring,

https://www.google.com/search?num=10....0.krorSj5acNk

[ryanjones2150]

Duct tape. It fixes everything.

[griff01]

buy a drum deheader there not that expensive, never use a torch. starting at about $45 and with shipping about $65.
the type I have is like the "Wesco 272303 Steel Vertical Slide Drum Deheader"

https://www.google.com/search?q=drum+deheader&num=100&newwindow=1&biw=960&bih=649&source=lnms&tbm=shop&sa=X&ved=0ahUKEwiOj-mk16zNAhXI6oMKHexrC8EQ_AUICCgB

a drum deheader works like a king size can opener,

don't take chances

for trash drums, I take the bungs out and turn over and cut the bottom out letting it fall to the "top" it keep the stuff in the drum and lets the water out if there an out side drum,

That drum deheader probably wont do a very good job welding a caster onto a drum like was being done in the video.

Griff

[Farmer Boy]

buy a drum deheader there not that expensive, never use a torch. starting at about $45 and with shipping about $65.
the type I have is like the "Wesco 272303 Steel Vertical Slide Drum Deheader"

https://www.google.com/search?q=drum+deheader&num=100&newwindow=1&biw=960&bih=649&source=lnms&tbm=shop&sa=X&ved=0ahUKEwiOj-mk16zNAhXI6oMKHexrC8EQ_AUICCgB

a drum deheader works like a king size can opener,

don't take chances

for trash drums, I take the bungs out and turn over and cut the bottom out letting it fall to the "top" it keep the stuff in the drum and lets the water out if there an out side drum,

[H80N]

There have been a ton of threads on the subject but maybe this video will help folks to THINK before they leap

Drum Explodes During Welding, Killing Worker

https://www.youtube.com/watch?v=9DP5l9yYt-g