Tweet
Hope this helps
-
-
Faceplate. It's pretty faded. The dial on the left is the amp range. Dial on the right is the fine amperage setting. The toggle switch below the fine amperage setting is idle and Weld power switch. The controls below the gauges are for the remote.Comment
-
Connections for gas etc.Comment
-
Aeronca41. Thanks for your help. It was the CR3 relay. Bad coil. So I took wire #107 and stuck it on the NC terminal. Welds great now. Both on AC and DC. Glad I didn't let the PO scrap itComment
-
Outstanding! Glad you had the background to dig in and fix it. Ya gotta love it when you can save a perfectly good machine from the scrap pile for little or no cost. Of course that tends to result in bringing home more "deals" than you reasonably need.....thankfully I have a very understanding wife..but even being retired, I have more projects than time. Then too, I'm a bit slower in the late 60's than I was 30 years ago. :-)Comment
-
@miklos <br />
Thanks for the pics, couldn't tell much from the last 2 pics, the first pic would be very helpful but its hard to read. Where did it come from and maybe I could find it.Comment
-
The first photo is off my welder. Inside panel where welding leads hook up. There is one similar in the owners manualComment
Comment