If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Took a chance from an off-shore supplier from you-know-where, (the Carribean, LOL). Let's see if this gambling/risk taking pays off. If not, who cares, it's just money.
HTP Invertig221 D.V. Water-cooled
HTP Pro Pulse 300 MIG
HTP Pro Pulse 200 MIG x2
HTP Pro Pulse 220 MTS
HTP Inverarc 200 TLP water cooled
HTP Microcut 875SC
for a special project.... ?? or just keeping stocked up..??
If my practice goes well, I might make a few hot-rod backyard projects from it. Only time will tell.
As for the quantity (10kg/22lbs), since it was being shipped on a boat from the Carribean (LOL), shipping wasn't exactly cheap, and obviously the more you buy the less you pay per pound, so I took a plunge (gamble, lol). Time (and practice welds) will tell if it pays off.
HTP Invertig221 D.V. Water-cooled
HTP Pro Pulse 300 MIG
HTP Pro Pulse 200 MIG x2
HTP Pro Pulse 220 MTS
HTP Inverarc 200 TLP water cooled
HTP Microcut 875SC
Hard to tell because I'm a newbie at adjusting the hydraulic down-feed, so I kept messing with it. I'd say maybe 2m:30s. Perhaps closer to 3min. On second thought, I suck at telling time. It was likely around 4min, lol.
Doesn't Matter. That was with the blade the saw came with. I had done previous cuts that took at least twice as long. I have the good Lenox blade still in a box.
HTP Invertig221 D.V. Water-cooled
HTP Pro Pulse 300 MIG
HTP Pro Pulse 200 MIG x2
HTP Pro Pulse 220 MTS
HTP Inverarc 200 TLP water cooled
HTP Microcut 875SC
Comment