Tweet
Is there a pin connector adapter to be able run a millermatic reach from a Trailblazer 301G? Thanks.
-
-
Do you mean the REACH feeder that was designed to plug directly into the MM350P..???Originally posted by [email protected] View Post
I think that has a 10 pin connector and the TB301G has a 14 pin
https://www.millerwelds.com/files/ow...44671E_MIL.pdf
You may be able to use a WC-24 just like you would use to adapt a 30A spoolgun to the TB
Think CRUIZER could either confirm or refute
https://www.millerwelds.com/files/ow...81712G_MIL.pdfLast edited by H80N; 03-18-2016, 08:16 PM..
*******************************************
The more you know, The better you know, How little you know
“The bitterness of poor quality remains long after the sweetness of low price is forgotten”
Buy the best tools you can afford.. Learn to use them to the best of your ability.. and take care of them...
My Blue Stuff:
Dynasty 350DX Tigrunner
Dynasty 200DX
Millermatic 350P w/25ft Alumapro & 30A
Millermatic 200
TONS of Non-Blue Equip, plus CNC Mill, Lathes & a Plasmacam w/ PowerMax-1000
-
Yes, exactly.Originally posted by [email protected] View Post
Would be really nice if the reach could work with both TB and MMComment
-
Unsure why you would go this route anyways when a VS feeder is just fineComment
-
-
Had a look see on the wiring diagram, sorry, there is no chance of a hookup other than the intended use. Pretty goofy system.Comment
-
I appreciate you confirming that for me. Thanks man. I guess I get to sell stuff to buy more stuff.Originally posted by cruizer View PostComment
Comment