If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hi, new to this forum. I have an issue with my Millermatic 180 auto. It migs fine as long as the wire speed is 60 or above. When I try to turn it down, the wire stops coming out and it's still making the sound like wire is coming out, but it's not birdsnesting. The mig gun only has a half dozen uses on it. My friend I bought it from used it exclusively for aluminum with the spool gun. I am putting out more wire than heat, and that's not good for thick stuff. Thanks in advance.