Announcement

Collapse
No announcement yet.

miller bobcat 225 starts and dies, power to the fuel shut off solinoid when cranking

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • paulsparts
    replied
    Not sure if this helps, but I dis connected the wire at the carb and installed a jumper to 12v runs fine, but idle solinoid wont engage and it runs only on fast, no welding current at the output.

    Leave a comment:


  • miller bobcat 225 starts and dies, power to the fuel shut off solinoid when cranking

    miller bobcat 225 SN MD011240R starts and dies, power to the fuel shut off solinod only when cranking. I have checked the #1 and #2 fuse ok, bridge rectifier 1 and 2 are good. main diode is good. by passed oil switch same thing. does this circuit get its power from the hour / idle control meter?
    Thanks
Working...
X