Announcement

Collapse
No announcement yet.

Need help with power for Dynasty 200

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • newtotig
    replied
    Thanks to all! Makes sense now. I went to to EL supply house, and got a male plug, no problem. I should be welding tomorrow!!! hopefully...

    Leave a comment:


  • bitternut
    replied
    Yep..........pjseaman is right on. Got mine wired exactly like that on a 20amp 230v receptacle. Works fine.

    Leave a comment:


  • Paul Seaman
    replied
    A friend of ours emailed me this when I was going through this exact same difficulty.

    GREEN = GROUND
    BLACK = HOT THIS IS THE SINGLE PHASE SET UP.
    WHITE = HOT


    TAPE THE RED UP AND DO NOT USE IT. IT IS THE ADDED 3RD HOT LEF FOR 3 PHASE.

    After you see this and look at the picture in the manual it will look familiar, trust me, been there done that{2 monthes back}!!!

    Leave a comment:


  • Guest's Avatar
    Guest replied
    Just be sure to wire it according to your manual.

    Leave a comment:


  • newtotig
    replied
    Yes! I knew there was something like that I just didn't know what it was Called. Thanks for your help!!!!!

    Leave a comment:


  • Guest's Avatar
    Guest replied
    Just get a 6-50p and wire it to the cord instead of changing the entire cord.

    Leave a comment:


  • newtotig
    started a topic Need help with power for Dynasty 200

    Need help with power for Dynasty 200

    Hi Everybody! I just came home with my new dynasty 200DX. The owners manual is very vaque about connection to AC input, only shows how to hardwire. My question is about the input power cord. I already have a 50A 220V outlet in the garage for my MM 200. Can I buy a 50A input power cord from my local electrical supply house, and wire it directly to the dynasty without worrying about voiding the warranty because I opened the welder case to change cord? Thanks!
Working...
X