If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I weld with a weave like NNNN and go quick across the center and hang out on the sides a count of one-two and back quick across the center. I have the mm210 and run c25 and .030 so for the machine it should be just about the same for you.
Always make it feel good for your hand speed since the settings on the door are to get you close.
Weld well,
Leave a comment:
Guest replied
I would set the machine to YOUR liking then when you run your bead just wiggle it a little bit. If it's not out of position then you should spray it.
If you spray you'll need something like a 98/2 gas.
ive got a mm251 runnin c25 and .35 wire, i usually just weld 1/4 or up to half inch. what should i do, run the settings on the door and weld straight or tweak the settings to my needs and use a weave or swirl... what do you recommend.
i usually just straight weld or back and forth along the weld which i think isnt proper method so if anyone could respond , it would really help
Leave a comment: