If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hey all who are interested the Miller Chopper built by OCC will be in Oxnard CA on friday january 21 from 10:00am to 3:00 pm.
It will be at PRAXAIR in oxnard. look them up if you would like to see it. I'll be there for sure
I did get a chance to see OCC chopper when it was in Albuq, it was interesting, but more interesting to me at the time was the Passport 180 they were letting a few people try out.
Regards, George
Hobart Handler 210 w/DP3035 - Great 240V small Mig
Hobart Handler 140 - Great 120V Mig
Hobart Handler EZ125 - IMO the best 120V Flux Core only machine Miller Dynasty 200DX with cooler of my design, works for me
Miller Spectrum 375 - Nice Cutter
Hey all who are interested the Miller Chopper built by OCC will be in Oxnard CA on friday january 21 from 10:00am to 3:00 pm.
It will be at PRAXAIR in oxnard. look them up if you would like to see it. I'll be there for sure
I got to see the bike at Miller here in Appleton. The paint job was great, but other than that it was hard to see inside the trailer. The bike is very wide, which was a supprise.
It's not the voltage that gets you, it's the amps.
Comment