Announcement

Collapse
No announcement yet.

Comment and Opinions......As I shamelessly Show off My Weld.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Comment and Opinions......As I shamelessly Show off My Weld.

    Very Large Photo;



    Steel Coupon, 1" thick X 7 ", 22.5 Bevel Each Side, 1/4" gap with 3/8" backing strip.
    3G Position.
    Welded with .045 Flux Core Inner Shield Wire with a Miller VS12 wire feeder, 320 IPM feed, 155 amps.

    Weld is not complete

    Regards
    "Equipment Should Never be an Excuse for Poor Performance. If You are Going to be a Professional, You Get the Correct Equipment, then the Only Excuse is Your Ability to Perform." ™

  • #2
    Is this for a test you are taking? I have been practicing for my 3/8 cert vertical up and overhead with 7018.

    Gary
    Dry Creek Welding
    Dynasty 300DX Tigrunner
    Trailblazer 302
    Spectrum 2050
    suitcase 12RC

    Comment


    • #3
      Yes, this is practicing. I am taking an AWS test 12/11/2004 for Flux Core.

      Regards
      "Equipment Should Never be an Excuse for Poor Performance. If You are Going to be a Professional, You Get the Correct Equipment, then the Only Excuse is Your Ability to Perform." ™

      Comment

      Working...
      X