help adding XR edge to a 350P

[HAWK]

Alex,

If you add the push-pull module to your MM251 be certain of your serial number. There are 2 different PP module kits for the 251 dependant on serial number.

[ASKANDY]

The Python WILL plug into the MM350P directly but you DO need the push/pull module if using a 251. The MM350P has the additional circuitry already in the machine to run the motorized pull guns where as the 251 does not.

Andy

[Alex]

Python?

HAWK,
If a Python gun will plug right into a MM350P, will it also plug into a MM251? The main reason I backed out of the notion of adding a python gun to my kit was because I'd heard that I had to add the MM251 push-pull module on the side. Together, they add up to nearly 2K.

Thanks,
Alex

[HAWK]

I ran a 30' Edge gun in the 300 amp range for a few months. It is a great gun, but oh so bulky unless you need it. The Python is the the way to go and reminds me a lot of some older smaller Cobra Matic units.

[rowyco racing]

python/xr gun

Thanks for the help ... he really seemed like he didn't know what he was doing and I didn't want to spend over $1500 for parts I don't need. I am not going to be running real high amp loads so I'll look into the python gun as you suggest. Thanks again for he help.

[ASKANDY]

your dealer is WRONG.

The edge gun will plug right into the 350P and the control cable will plug into the 10 pin receptacle on the front of the machine.

It will run fine.

?? Why the edge gun? Are you going to be at high amps? The reason I ask is that the Miller Python gun is smaller and easier to use but has a lighter amp rating.

Andy

[rowyco racing]

I went in to my local dealer today to purchase a 350P and a XR edge push pull gun. My dealer said that to add an XR gun I would need to buy the whole push pull conversion kit (which is about 1/2 the cost of the welder!) even though the 350P is advertised as being already set up to accept the XR guns and he didn't think I needed all of the kit. Does that make sense to anyone using that set up? It sounded like I'd be buying a bunch of stuff I didn't really need with the 350P and the dealer seemed pretty unsure of what to order. Made me nervous enough that I held off on the pruchase until I can make sure I'm getting the right stuff. Specifically he said I'd need the 350P + the XR (Miller part #181 535). Any help would be appreciated.