I have a spectrum 375 and has performed flawlessly. I run mine on 220V and have had no problems with it. I have herd about the cord problem but I dont know if it applies when running 220V, however I'm willing to give it a try. I have the wheel stand off kit and it makes cutting 20 through 10 ga sheet metal almost as good as cutting it with a shear, provided you have a straight edge. I have also cut 3/4 plate with it, ya have to go very slow and it dose'nt do a great job but for a machine that was rated for 3/8 it works great.
I also bought the circle cutting guide, it was very expensive but it works sweet

I like the fact that it will run on 110 or 220V and is portable.
If your not cutting super thick (.625 or bigger) all the time this is a fabulous machine.
Leave a comment: