Announcement

Collapse
No announcement yet.

Hard facing hard steel...

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • paulrbrown
    replied
    Bulldog, try this site, it is McKay rods who should be able to give the info you need, they are part of Hobart so don't freak when it comes up...
    http://www.hobartbrothers.com/mckay.asp

    Leave a comment:


  • Bulldog
    started a topic Hard facing hard steel...

    Hard facing hard steel...

    Hi everyone,
    I liked all the nice and insightful comments on welding with the kids. Well me and the kid have some hard facing to do on some hard steel. I have a company that has a concrete block mold that's worn pretty good and they need me to make 25,000 retaining wall blocks starting on Sat. The o.e.m. needs 6 weeks min. to produce the parts. I told them that I would bring them to my shop and build them up and hard face them. I know that this works I've done it plenty of times in the past. I have never used my mig however. This finally brings me to my question... What wire should I use? The steel is a rockwell 72 - 76. I don't really know the exact make up but I've built up parts in the past with 7018 and have run a Lincoln wearshield stock # ED021996 over that. Then a lot of time with a grinder and polisher I have a usable part. So any advice from any of the GOOROS on the site would be very much appreciated!
    Bulldog
Working...
X