Announcement

Collapse
No announcement yet.

spool gun off of trailblazer

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • spool gun off of trailblazer

    Some oneasked about this a while back,i would like to run a spoolgun off of my trailblazer 301g.i have used the big spoolgun off a miller 251 mig machine.i know i need a control box for the 14 pin recp.but how do i set the wire feed speed?does the control box have a digatal readout?its been a while since ive used the spoolgun but i believe the wire speed control was at the bottom of the pistol grip.The trailblazer is a great machine.i would just like to use it to its fullest ,instead of buying a mig machine for aluminum.

  • #2
    The SpoolmaticĀ® 30A Spool Gun should work...

    Comment


    • #3
      10-4

      The Spool 30A has wire speed control on the bottom of the gun handle. It is not digital so you will need to experiment on the settings.

      Andy

      Comment


      • #4
        I'm haveing the same problem whenever I need to use my Miller Spoolmatic 4-pin without a weld control box with a Miller 300xmt 14-pinout-So far have not been able to find any adapters or work-around solution-
        Good luck

        Comment


        • #5
          boilerman79,

          Just dial in the voltage on your trailblazer. Each wire size has a sweet spot. I shoot for that voltage, connect the 30A via a WC24 and adjust the wire speed by the gun handle as Andy mentioned. It is a great set up. I ran one for quite a while: TB301G, WC24, and 30A.

          Comment

          Working...
          X