That being said, I too would have to reccomend the Dynasty 200DX. It is just a hard machine to pass over when you look at VALUE and PERFORMANCE. Yes it is more money than a 180 or 250 Syncrowave, but for what you get, it is a great deal.
I would tend to look at a Spectrum 625 over the 375 also. The 625 will cut thin material just fine, but you can't make a smaller plasma cut more than it was intended to. I have lo's of people wanting to trade up to larger plasmas after buying 1/4" and 3/8" capacity machines, but nobody ever wants to trade down.
The decisions are yours, only you know what you need today. And you know best what you may want the capability to do in the future. Good luck with your decision, hope we were of some help...

Leave a comment: