Announcement

Collapse
No announcement yet.

shop pic

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Qrazy
    replied
    Yes Sberry, some of us from the Hobart forum have seen them, as well as us Ford Truck forum guys...But I still liked looking at them again
    P.S. You do a great job of steering the welding questions on the truck forum. You always give them clear concise answers to their questions. Well done...

    Thanks,
    Qrazy

    Leave a comment:


  • cope
    replied
    Sberry

    You need to post the close-ups of the welder on the service truck.

    Leave a comment:


  • ASKANDY
    replied
    I don't even know what it's like to drive a vehicle in the shop lately
    My shop feels like that 5 lb bag with 10 lbs in it.

    a-

    Leave a comment:


  • Paul Seaman
    replied
    I would spray the walls and drywall, then styro foam board the roof, and drop the ceiling to right below the truss line with a layer of pink, to create a air gap between the roof and ceiling.

    Just an opinion,

    Leave a comment:


  • Sberry
    replied
    I have a standing seam roof and there are clips, standoff types thet keep from totally compressing the rolled fiberglass against the purlins. I think if I was to do it again,, and I might add yet I would go to 2 inch urethane foam board under the purlins. It would allow for ventalation between the insulation and the roof sheeting. For the most part I am happy with it and have ceiling fans to keep the heat down. My helper and I built the building,, complete except hired some help with sheeting and pouring the floor. Before I do more here I need a new equipment storage build,, maybe this summer. I am leaning towards a 60x120 on that. This one is 80x80 and if I had the dough I would have went to 100 long,, mainly just to get some more running wall space for tools.

    Leave a comment:


  • tackit
    replied
    Nice set up Sberry I would get lost in that place. I would be interested in knowing about the insulation too. thanks

    Leave a comment:


  • Guest's Avatar
    Guest replied
    How is the shop insulated? I have an 800 sq ft metal shop here in Louisiana and need to get it a/c but must insulate. I have been told "spray" is the best. Anyone else got any thoughts?

    Thanks To All

    Leave a comment:


  • Sberry
    replied
    Here is a tour.
    http://www.ford-trucks.com/user_gall...?userid=132195

    Leave a comment:


  • Sberry
    replied
    Service truck, quite complete.
    Attached Files

    Leave a comment:


  • Sberry
    replied
    Benches and scrap steel rack in background.
    Attached Files

    Leave a comment:


  • Sberry
    started a topic shop pic

    shop pic

    Most of the guys on the Hobart board have seen these.
    Attached Files
Working...
X