Announcement

Collapse
No announcement yet.

Fifty ton press I built

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • tackit
    replied
    God job timw, I've thought of doing something like that to mine too.

    Leave a comment:


  • timw
    replied
    Here's an addition that I added to my 20 ton press. I got tired of taking my work and the plates off to ajust the bed so I added an old boat winch to the top with a pulley on the other side and cables to the bed. Now I can crank the bed up or down with weight on it and move the pins.
    Attached Files

    Leave a comment:


  • tackit
    replied
    I hear you pjseaman.

    Leave a comment:


  • Paul Seaman
    replied
    tackit:
    That is a great rule, I have a very small shop and it takes effort on a daily basis.
    Peace,

    Leave a comment:


  • tackit
    replied
    Thanks HAWK, I try to clean as go and make sure each night when I finnish the shop is swept out and the tools are put back in their right spot, I can't stand searching for my tools.

    Leave a comment:


  • HAWK
    replied
    NICE CLEAN SHOP!

    Leave a comment:


  • cope
    replied
    I had a 30 ton press and thought it was big. That should handle anything that fits in its jaws!

    Leave a comment:


  • tackit
    started a topic Fifty ton press I built

    Fifty ton press I built

    Heres some pics of the 50 ton press I built last fall. It's legs are made of 1X5", the channel bed and top rails are made of 8" X .312? (heavy stuff.) I have ten inches of open space between the legs and the work opening is 32" wide, it's height is 74". Got the steel at the Salvage place $250 and I believe the hydraulic pump and cylinder was about the same. The feet were made by cutting the same 8" channel in half.

    I stick welded the legs to the top rails and used a Unitec mag drill to drill the pin holes which came out perfectly aligned and square.
    I plan on building some dies and I will buy some.

    I use a 1x12 square steel base on top of the bed rails to work on.

    Now I just love it when things warp or need to be straightened.

    Nothing exotic but it was a fun and a useful project to build.

    Thanks for looking.

Working...
X