Yes, I should have started this post with " set up per door chart, then if..........
A poster on this board sent me an Email with his definition of this subject.
Wire speed = penetration
Voltage = bead height and width
Fine tune accordingly.
Until a better description comes along I will heed his advice.
Once I start Migging I will follow the advice of other experienced weldors. Practice!!
Thanks to all who contribute info. Makes the newbies (me) job easier.
Never too old to learn.
moe1942
A poster on this board sent me an Email with his definition of this subject.
Wire speed = penetration
Voltage = bead height and width
Fine tune accordingly.
Until a better description comes along I will heed his advice.
Once I start Migging I will follow the advice of other experienced weldors. Practice!!
Thanks to all who contribute info. Makes the newbies (me) job easier.
Never too old to learn.
moe1942
Comment