High amperage single phase plugs 60 amp.

[Portable Welder]

Thanks guys, I ended up using a russel stohl 60 amp.

Look at the Hubbell CS-8265C and mate locking connectors.

[BukitCase]

"My 50 amp plug single phase plug that I use on my miller matic 252, MM200 etc. The 50 amp plug is 50 amps per hot leg."

Not exactly true - 240 volt SINGLE phase has two busses that are 180 degrees out of phase with each other, so when one is positive the other is negative - either leg to ground/neutral would be 120 volts.

So with the Nema 6-50 you really only have ONE 50 amp circuit at 240 volts, and a ground... Steve

One word:

HUBBELL

One reason:

THE BEST THERE IS

[USMCPOP]

There are some 100A ProPin 250V connectors on eBay for around $35. each. The pin spacing is different.

[Broccoli1]

No voltage specs but a bit cheaper:

http://www.stagelightingstore.com/Stage-Lighting-Store/Stage-Pin-Cable-Mount_3

I see the Bates 100A plugs are 125/250V but are close to $50 each.

Those are 100amps 120v. Pin spacing.

Doesn't look like they have an option to order 240v.

[USMCPOP]

No voltage specs but a bit cheaper:

http://www.stagelightingstore.com/Stage-Lighting-Store/Stage-Pin-Cable-Mount_3

I see the Bates 100A plugs are 125/250V but are close to $50 each.

[Broccoli1]

What about 60 and 100 Amp Stage Plugs? Ed, do you have any input?

60amp are 120v.

You can get 100amp 240v but he would need both female and male connectors.
$49.99 per connector.

http://www.filmtools.com/gripdept/ba100ampcapl1.html

Certainly a possibility if one really needs to disconnect but they are designed for #2 individual cord and I think the 350p has 6g wire in the power cord-might be 8g.

[USMCPOP]

... Single phase 60 or 70 amp combos aren't cheap!

What about 60 and 100 Amp Stage Plugs? Ed, do you have any input?

[WillieB]

okay then looks like I need to buy another Russel stohl plug and run it off that if I want to meet code.

A three phase receptacle, supplied with single phase power does not comply with code.

Single phase 60 or 70 amp combos aren't cheap!

[Portable Welder]

Thanks for everyone's input.

[Broccoli1]

okay then looks like I need to buy another Russel stohl plug and run it off that if I want to meet code.

You can use the Multiplier to find out if the 6-50 connector will work within code

Applies to conductors and connectors.

http://ecmweb.com/qampa/code-qa-45

[Portable Welder]

okay then looks like I need to buy another Russel stohl plug and run it off that if I want to meet code.

[Portable Welder]

Okay then, My 50 amp plug single phase plug that I use on my miller matic 252, MM200 etc. The 50 amp plug is 50 amps per hot leg.

[Sberry]

The 50A plug will work fine for that machine.