If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Could a conductor adjuster go bad on these?? Reason I'm asking is I don't get any arc while I have it mounted buy soon as I unscrew it from the plate is seems to work. Possible kinked wire or bad conductor
conductor adjuster.... not sure about that one. So what I think your saying is once you mount your welder on your deck, you have no arc.. Is this correct?
Tweet
Comment