30a spoolgun to lincoln 210mp is it possible?

[Tryagn5]

Just picked up my mp210 is it possible to hook the 30a to it
? Going to be reducing my welding equipment as i have spent the last 2 years being an employee vs a employer.
Kevin

[cruizer]

Easy, think it's a 16 series 7 pin clocked to W, which you will need

[Tryagn5]

Easy, think it's a 16 series 7 pin clocked to W, which you will need

Where would i get this cable? Also will a wc24 be needed?
Thanks
kevin

[cruizer]

Well no cable needed nor a we-24, you merely cut the 10 pin off, solder the existing wires on the new 16 P amphenol and plug it into the 210's spool gun connector

That said I haven't seen the service manual on the Lincoln. Pretty sure there is the 7 pin. You can make a 10 to 7 pin adaptor if you intend on moving the spool gun around.

[Tryagn5]

Well no cable needed nor a we-24, you merely cut the 10 pin off, solder the existing wires on the new 16 P amphenol and plug it into the 210's spool gun connector

That said I haven't seen the service manual on the Lincoln. Pretty sure there is the 7 pin. You can make a 10 to 7 pin adaptor if you intend on moving the spool gun around.

I will check sunday to see if it has the 7 pin. Also do u sell the 10 to 7 pin adaptor?
Thanks
kevin

[cruizer]

Ok, not possible, unlike its larger cousin, this one uses the 100sg magnum. If the machine didn't have to control the wire speed, the connections would have been simple enough