What wire feeder to use with my syncrowave 350?

[H80N]

CC vs CV Supplies...

Hi all,
My first post. I'm in the market for a wire feeder to use with my Syncrowave 350. I want to add SMAW and FCAW to my arsenal, and want to get the most versatility for my dollar. I do mostly small fabrication jobs and repairs right now, but would like to expand when I retire from active duty. Thanks in advance for your ideas and suggestions.

The Sync 350 is a Constant Current power supply and would make a very poor supply for MIG.... ideally you want to find a Constant Voltage supply like an XMT or an All in One like a MM200 if you want to run more than just fluxcore...

Yes you can run a Voltage Sensing feeder with a Sync but your results will likely be frustrating and disapointing...

[DIVERDON]

Hi all,
My first post. I'm in the market for a wire feeder to use with my Syncrowave 350. I want to add SMAW and FCAW to my arsenal, and want to get the most versatility for my dollar. I do mostly small fabrication jobs and repairs right now, but would like to expand when I retire from active duty. Thanks in advance for your ideas and suggestions.