Announcement

Collapse
No announcement yet.

extension cord

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • ASKANDY
    replied
    outkast,

    8-3 will be fine for your 210. However, if you choose to purchase a TIG machine at a later date, you may want to get the 6-3 now and save the hassle of getting 2 cords.
    Just a thought...

    A-

    Leave a comment:


  • Paul Seaman
    replied
    Cool, how much did it set you back?

    Leave a comment:


  • Guest's Avatar
    Guest replied
    I have the SO 8/3 cord and it was purchased at HOME DEPOT.

    Leave a comment:


  • hankj
    replied
    Extension cord

    outkastkustoms,

    In the hardware store I work at the largest ready-made cord we sell is #10 - good for 25-30 amps max. For 25', #8's will do you good, #6's will give you plenty of margin. SO covered is the right cord to use; the ends will cost you as much or more than the wire. Whatever, be SAFE!.

    Be well.

    Hankj

    Leave a comment:


  • Paul Seaman
    replied
    On my mm210 I use a freebie extension cord made from a SO cord 4ga 3wire its over kill but so what. Oh yea, its only 100' long so you might not want a 150 pound cord get the 6/3 or 8/3 as long as it is not over 100' you wont get amperage drop off to worry about.

    According to the wiring code book I have, 1989 model, 40 amps at 100'requires minamum of 10/3 but this is min not my suggestion. I would like 8ga 3wire but buy an Outdoor rated SO cord. this should be available at the electrical supply house. Good luck, weld well

    Leave a comment:


  • MACH4
    replied
    SoCalTA,
    This a type of wire that we use at my "day" job for our welding ext. cords and I went to one of the local electrical suppliers and told them how much I wanted and then all I had to do was install the proper outlets for my welder. I have NOT seen this type wire at the area Lowe's or Menards, however your area may carry it. I would look to a supply house before the aforementioned. I believe I gave $1.26 per ft. for this wire {works great}.
    Mike
    MACH4

    Leave a comment:


  • SoCalTA
    replied
    Mach ...
    Is the cord you described a HomeDepot/Lowes item or a specialty store?

    Leave a comment:


  • MACH4
    replied
    outkastkustoms,
    I run a 40ft. extension for my MM210 and I use 6-3 SO wire, it's got a pliable rubber coating. It is fairly flexible so you can roll it up for storage. Hope this helps.
    Mike
    MACH4

    Leave a comment:


  • outkastkustoms
    started a topic extension cord

    extension cord

    ok I have had my mm210 for a week now and am going to finally wire in 220 today, I have a 40 amp breaker, 15' of 6-3 wire going to the plug in, I will be doing most of my welding with the welder directly in the wall, but from time to time i will need to move around, i want to get a 25' extension cord and was wondering what size cord i should get, I want the least amount of power loss
Working...
X