Announcement

Collapse
No announcement yet.

2005 Bobcat 250 D NT won't stay running

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Rezeppa
    replied
    2005 Bobcat 250 D NT won't stay running

    Thank you for the response. Unfortunately after calling my two local welding repair facilities they are unable to look at my welder for at least month. Your information was quite helpful I was not completely sure what sensors this engine was equip with so now I can diagnose the problem better thank you. If there is something you think would be something more likely to fail over something else please let me know so I can check there first.

    Leave a comment:


  • cruizer
    replied
    Alot of variables here, obviously a fuel problem, so , low oil, bad coolant sensor, bad murfy switch, bad wireing to and from the power board. Best just take it in somewhere for diagnostics

    Leave a comment:


  • Rezeppa
    started a topic 2005 Bobcat 250 D NT won't stay running

    2005 Bobcat 250 D NT won't stay running

    Hello and thank you in advance. I have a 2005 Bobcat 250 D NT. The welder starts fine no issues runs anywhere between 10-30 minuets then quits. When running it idles up and down normally and welds great. When it does quit it won't stay running for over 5 minuets it just quits. If I hold the fuel shutoff solenoid in it will run until I let go. I am trying to figure out if it's the solenoid or something else any and all help is appreciated.
Working...
X