If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Bluetooth / wireless TIG pedal on older Synchrowave machines
Older synchrowaves like the ones with the 5 pin, then not a direct fit, you'd have to convert the 5 to a 14 pin, otherwise sure. all these units use the same 5 basic pinouts. A& B are contactor control. C,D,E are the control pot.
I spoke with what sounded like a younger guy. Name was "Boone". I wish these guys at Miller were better versed than what they are!!!
The hook up didn't sound that complex but when I hear from Miller that it cant' be done I wrote it off as over. I understand that they need machines to sell but come on now.
Comment