Bluetooth / wireless TIG pedal on older Synchrowave machines

[PlasmaGuy]

Ok

Cruizer,

Thank for chiming in...

I spoke with what sounded like a younger guy. Name was "Boone". I wish these guys at Miller were better versed than what they are!!!

The hook up didn't sound that complex but when I hear from Miller that it cant' be done I wrote it off as over. I understand that they need machines to sell but come on now.

As always thank you for your excellent advice !!!

Tom

[cruizer]

Older synchrowaves like the ones with the 5 pin, then not a direct fit, you'd have to convert the 5 to a 14 pin, otherwise sure. all these units use the same 5 basic pinouts. A& B are contactor control. C,D,E are the control pot.

[PlasmaGuy]

Update

If the synchrowave is not a "DX" then it is not going to happen

[PlasmaGuy]

Does Miller offer the wireless TIG pedal as an add-on?
I'm guessing no but Cruiser or others will definitely be in the know.

Thanks,

Tom