Announcement

Collapse
No announcement yet.

syncrowave 250dx current draw

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • H80N
    replied
    Originally posted by akm06 View Post
    Is 90 amp overcurrent protection (breaker) with#4 thhn sufficient for a syncrowave 250dx?
    probably a little light on the breaker depending on the input voltage you have it strapped for.....

    take a look at section

    3-19. Electrical Service Guide
    . For 250 DX Models

    page 23 in the manual

    http://www.millerwelds.com/om/o363q_mil.pdf

    BTW... the Syncrowave is a Single Phase ONLY machine..
    Last edited by H80N; 01-06-2015, 04:01 PM.

    Leave a comment:


  • Robert Hall
    replied
    Originally posted by akm06 View Post
    Is 90 amp overcurrent protection (breaker) with#4 thhn sufficient for a syncrowave 250dx?
    Single or three phase?

    On the back of the welder is a table, usually a black label, that tells you the amps at a given voltage.

    Leave a comment:


  • akm06
    started a topic syncrowave 250dx current draw

    syncrowave 250dx current draw

    Is 90 amp overcurrent protection (breaker) with#4 thhn sufficient for a syncrowave 250dx?
Working...
X