Announcement

Collapse
No announcement yet.

XMT 300cc problems.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • XMT 300cc problems.

    My boss gave me this welder and I would like to get it functional. I am not sure what is wrong with it other than it is non operational. I am electrically inclined so anything you may need me to check I can in due time. It is wired for 230v single phase. I have notes from someone who had previously looked at it and hope they may help. I also understand that autolink was in its early stages and had issues if this is what is determined to be wrong I am hoping that I may bypass this because it will never be used with any other input other than single phase 230.

    Everything is checked off in his diagnosis sheets except for

    The notes state that
    Board PC1
    RC2 pin 1 is reading 24vdc
    RC2 pin is reading 0

    Board PC6
    From RC16-5 to RC16-6 he had a "?" and a reading of 32VDC

    Thanks for any help you may provide me. I am really looking to find the root of the issue I am not the kind of guy that likes to replace a whole board because one 15 cent resistor is bad.


    God bless and Merry Christmas
Working...
X