Announcement

Collapse
No announcement yet.

Miller 200 AEAD will not idle up help pleas

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • mach21
    replied
    Ok thank you and i gave you the engine serial number the welder SN#HK264071

    Leave a comment:


  • cruizer
    replied
    There is a couple boards on the side of the machine, one has a fingered heat sink with 2 small SCR's. One of those scrs is blown. Think they are To220 8 amp 200 volt units. Just replace those. you can get them from: www.digikey.com

    Leave a comment:


  • mach21
    replied
    OK diaghram on the internet that seems to be it hooked up a ground tested the switch it works but still will not idle up. Should i just buy a aftermarket idle board from weldmart? Also tested idle seloinoid and it does retract. Any information on what other parts to test i have neber tested a circut board so i do not no how to go about the idle board test.

    Leave a comment:


  • cruizer
    replied
    Unsure what model your machine really is. never the less, yes, the power/weld switch has 2 wires, 1 to chassis and the other to Switch S1

    Leave a comment:


  • mach21
    replied
    model ccka-ms/36700

    serial # c790398437

    Leave a comment:


  • cruizer
    replied
    There is olnly like 15 AEAD circuit diagrams.... Serial#

    Leave a comment:


  • mach21
    started a topic Miller 200 AEAD will not idle up help pleas

    Miller 200 AEAD will not idle up help pleas

    I just got this machine runs good welds but will not idle up. I started looking at things and the idle switch only has one wire running off of it is this correct? And if some has pictures of the idle board while connected and the idle switch they could post that would be greatly appreciated thank you.
Working...
X