Announcement

Collapse
No announcement yet.

Wire feed problems

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • cruizer
    replied
    I think thats 50K ohms, never the less, likely a charge cap issue, unsure why your replacing parts willy nilly. Send the board out for over haul.

    Leave a comment:


  • Craftsmanatlarge
    replied
    Did you disconnect the wires from the pot before measuring? If not you would get bad readings like that.

    Leave a comment:


  • Stacyharper
    started a topic Wire feed problems

    Wire feed problems

    I have a miller matic 135 that will only feed wire at high speed I replaced the Q1 transistor and the speed pot reads 50oms when it is set at 0 and slowly goes down to 0 when turned up can anyone help
Working...
X