Weld Controller

[fabricator]

Thanks

[H80N]

You need a WC-115A #137 546-01-1

Try here:
http://www.millerwelds.com/products/wire_feeders/spoolgun-chart.html

http://www.millerwelds.com/pdf/spec_sheets/M1-76.pdf

+1 on the WC-115.... for a 30A/15A

The BOBCAT does NOT have the 24 pin connector... thus cannot use a WC-24...

If it were a Trailblazer.... the WC-24 would be the hot ticket...(the TB has the 24 pin socket)

I would NOT even think about a 3035 spoolgun outside of a hobby setting...
invest in a 30A and have years of trouble free commercial service... they are bulletproof..

[GlenC]

You need a WC-115A #137 546-01-1

Try here:
http://www.millerwelds.com/products/wire_feeders/spoolgun-chart.html

http://www.millerwelds.com/pdf/spec_sheets/M1-76.pdf

[walker]

Both have different requirements. 30a requires a WC24, 3035 uses a SGA100C. May be other ways as well.

Hook up chart http://www.millerwelds.com/products/...gun-chart.html

[fabricator]

Which weld controller is required to run a 30A or 3035 spoolgun off a new bobcat?