Mm250 wire feed issue

[driver]

Hi i recently bought a used MM 250. Very clean machine ive only used it a handful of times ans its worked great untill today. I was using it and the wire feed died. all the conections seem good i can hear the gas relay clicking and also another clicking coming from the board i have check the reset and its good. Any advice would be greatly appriciated as i have a big project coming up in the next 3 weeks thanks

[cruizer]

Since you hear other clicking, going to say that your gun is bad, Remove the gun trigger, and jumper the machine terminals, 1&2. Bet the machine works fine.