Syncrowave 210 will not boot up

[blue_tech]

How much voltage do you measure from heatsink HS6 in reference to heatsink HS2 when the unit is turned on?

It should measure about 440 VDC when the boost circuit is operating properly in the PC1 board.

[gunnare]

I’m having the same problem with my syncrowave 210. Did you ever find a solution to this problem?

[cruizer]

OH, yeah its one of those odd units. It's likely stuck on 220, best bring it in, as its having voltage switch issues. The unit senses input voltage, and isn't sensing to drop to 120

[Bob Welder]

I was using the machine on 110 Volts

[Kpack]

Are you running it 220 ? Just flip the breaker off and back on like cruzier said.

[Bob Welder]

It is a single phase 110/220 machine

Turn your breaker off then back to on . Your missing a phase

It is a single phase 110/220 machine

[cruizer]

Turn your breaker off then back to on . Your missing a phase

[Bob Welder]

I just bought a Miller Syncrowave 210 welder two weeks ago
today I welded for some time
took a break for lunch
turned it back on
display board displays Syncrowave 210
no menu options come up
any suggestions
Thanks
Bob