Announcement

Collapse
No announcement yet.

Torch hookup issue Dialarc HF

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • fishbum
    started a topic Torch hookup issue Dialarc HF

    Torch hookup issue Dialarc HF

    Bought a older Dialarc hf the other day has a water cooled tig torch
    that had a large fitting on gas hose. But machine has the small fittings
    like the size of the water like 3/8 or so. What has been changed?
    is there something missing? Will a different air tourch work? Thanks

  • fishbum
    replied
    Tig block

    Thanks.

    Leave a comment:


  • cruizer
    replied
    Well you have a switch to reverse the polarity, however work clamp goes to the left, tig torch to the right, I mentioned you'll need a "short chunk of gas hose" for the machine and tig block.

    Leave a comment:


  • fishbum
    replied
    Tig block

    Hate to be so dense but on the welder it has two large studs one on left says work! The other says electrode! Is work the ground? And electrode the tig where the tig block goes? And does the gas out connection go to the small side of the tig block? If so there must be a small jumper gas hose right? Thanks

    Leave a comment:


  • cruizer
    replied
    Local welder supply

    Leave a comment:


  • fishbum
    replied
    Tig block

    Oh ok, where can I find one

    Leave a comment:


  • cruizer
    replied
    Tig block goes to your elecrode output stud, , fits the air cooled tig torch, and with a smaller hose going to your gas adaptor on your machine. You'll need a short chunk of gas hose with fittings as well
    Last edited by cruizer; 07-26-2014, 02:23 PM.

    Leave a comment:


  • fishbum
    replied
    Tig block?

    What does it look like? Does it fit in one of the other fittings?
    thanks.

    Leave a comment:


  • cruizer
    replied
    Cause your missing the tig block

    Leave a comment:

Working...
X