Help 7 merely means that you output board caps can't maintain a proper charge and can't discharge, If you were to remove the cover, or the right side there are a couple large capacitors under that "output" board. Remove the 4 5/16" head cap bolts, pry the board back slightly, and with a ohm meter check the resistance. must be around the 18 K ohm mark. If not just order one or 2 from Dijikey. I remove the board then flame the old ones off, much easier that a soldering gun. and put the new ones on.
You can change them out with the 20K versions ohmite part# L25J20KE
Announcement
Collapse
No announcement yet.
Xmt 304
Collapse
X
-
I am sure Dwayne or Cruizer will be by shortly. Here is some leisure reading in the mean time. http://www.millerwelds.com/resources...-xmt304-help-7
Leave a comment:
Leave a comment: