Announcement

Collapse
No announcement yet.

Aluminum Tig AGAIN!!!!!!!!!!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Aluminum Tig AGAIN!!!!!!!!!!

    Still looking for pointers on tiggin' AL. Switched from 100% to a Zirconiated and have gotten better results but, still doesn't look as good as SS or carbon tig.Can't get the "stack of dimes" look that I keep hearing about. Any and all hints appreciated!!!
    Mike

  • #2
    MACH4..........Where are we at here......... Are we still paacticeing........or have we improved.......Aluminum require's a bit of a knack...........Let us know..........Rock..
    [email protected]
    ROCK

    Comment


    • #3
      Rock,
      The welds are looking much better, not sure if it's the switch from the 100% to the zirconiated , but I think I'll just keep workin' at it. I tend to be a bit of a "perfectionist" so I get a little paranoid if my work does'nt "look" the way I think it should! Thanks for the reply.
      Mike
      MACH 4 Welding

      Comment

      Working...
      X