Announcement

Collapse
No announcement yet.

Water-cooled tig torch conversion fail

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • mx_racer428
    replied

    Leave a comment:


  • mx_racer428
    replied
    Originally posted by big mike View Post
    It does not look like you used a 195380 dinse adapter. How did you hook up weld power and water to the torch?
    The adapter wil facilitate hook up of power(return water) and gas.

    Does you cooler have an Oberdorfer pump or Procon?
    Not sure at all about the cooler. As for the adapter it is the correct one. Seporate a the gas and return water, sure wasn't cheap.

    Leave a comment:


  • big mike
    replied
    It does not look like you used a 195380 dinse adapter. How did you hook up weld power and water to the torch?
    The adapter wil facilitate hook up of power(return water) and gas.

    Does you cooler have an Oberdorfer pump or Procon?
    Last edited by big mike; 12-11-2013, 08:07 AM.

    Leave a comment:


  • mx_racer428
    started a topic Water-cooled tig torch conversion fail

    Water-cooled tig torch conversion fail

    Morning all,
    I have a slight issue that I was hoping this group could help me with. I recently finished converting my syncrowave 200 to a water cooled torch. I went to weld some aluminum for the first time after converting and I cannot get it to weld, seams like I'm not getting any etching action and the weld pool instantly contaminates. Can't add any filler or anything. I swapped to my air cooled torch and it runs perfect. Not sure what ls what's going on. Here's my current set up.



Working...
X