Tweet
Anyone out there have any experience with the Invision 345MP and XR control for aluminum? We do a lot of Al fabrication for marine, mostly 1/8 to 1/4 sheet but sometimes get an unusual job requiring 1/2 to 5/8. I am also looking at the Pulser (MUCH LESS EXPENSIVE!!) but don't have any experience here either. I have only used the Miller 210 with spoolgun with great results but since I am ready to make an investment I thought I would see what experience was out there. Any thoughts?
-
-
CALPLUS;
The Invision 354MP and the XR Control will be a very good choice for your aluminum welding needs. Please send me either your email address or phone number to my email address below and I will forward it on to the weld engineers that are familiar with those products at Miller Electric.
Steve
[email protected] -
calplus,
Stay away from the MM Pulser for that thick of material. It's nice on the thin stuff but runs out of steam on the thickness you are looking at. The Invision is a great unit or you may also try the MM251 or MM251 push/pull system.
AndyComment
Comment