No announcement yet.

Older 5 pin tig pulse control

  • Filter
  • Time
  • Show
Clear All
new posts

  • Older 5 pin tig pulse control

    Have a dialarc HF and the other day I went to go buy a Mic 4 interface control so I could use some 5 pin foot control and finger controls that I have and the guy had pulse control sitting there. Looks much like the PC 300 that I've seen before but older looking and with the 5 pin in and out. It was an estate sale and the guy didn't know much about it I took a chance and grabed it. I'm not sure if its just not meant for the old dialarc or if its not working. Mic 4 is working fine. With pulse hooked up to mic4 and on welder it act the same with no change. Checked the basics on/off switch and power going to and out of transformer seems ok. Any ideas??Click image for larger version

Name:	image.jpg
Views:	1
Size:	59.4 KB
ID:	532415
    Last edited by kevdidy; 09-20-2013, 01:25 PM. Reason: Move picture

  • #2
    I curious about this as well, I have a 90s model dialarc HF and a mic-4 interface, I just want to know if the pulse controller would work together like you're trying to do, oh well we'll see if anybody else can chime in