Need to make steel rings

[Bossman2000]

Hi would this machine be able to bend a 25 mm/ 1 inch bar into a 360? If anyone has and recommendations I'd appreciate. I don't have any heat (propane). I'm trying to avoid renting.

[bayweld]

With that bender you may have to make the rings in halves and weld them together...Good luck

[chewinggum]

1" steel bar, no heat, and that radius? I think you are in trouble.
CG

[MMW]

No it won't. That is a tubing bender & you are asking about bar. Big difference.

[Bossman2000]

Need to make steel rings

Could it be done with heat and that bender? I've been on to a gas supplier and now you can buy the propane canister/cylinder. So I will have heat.

[Bossman2000]

Need to make steel rings

Bayweld I never even though of welding the two halls together, genius!!

[Broccoli1]

Could it be done with heat and that bender? I've been on to a gas supplier and now you can buy the propane canister/cylinder. So I will have heat.

No

Round Tube Capacity 7/8"
Wall Thickness .047"
Square Tube Capacity 1"

[aametalmaster]

Burn em from 1" steel plate and do a round over to suit...Bob

[Broccoli1]

How many do you need to make?

this might work for you

http://www.westechrigging.com/riggin...are-rings.html

[walker]

You can heat bar stock in a forge and bend them around a piece of tube with no problems. Forge is easy to make.

[Country Metals]

I would either sub it or burn them from plate

[MMW]

Question to the op.

How many do you need to make/buy? What exactly is the use?

[turbo38t]

You can buy those.... http://www.liftingsafety.co.uk/produ...ings-2424.html

[Bossman2000]

Need to make steel rings

@turbo they're a bit pricy at 21£

[Bossman2000]

Need to make steel rings

@mmw initially 10 for Highland games, but if I get the bending right I've railing to make up so plenty of bending to be doing 180's though not 360's bends.