Tweet
When welding during the day When it gets warmer about 90°, The machine turns over but does not start up It takes two or three times before it starts up . Does anyone have any ideas what it could be ! Please help !!!
-
-
Maybe the carb's main jet needs to be opened up....it's set to lean..... -
Problems with Pipepro 350
Where would one find the carb on a diesel? Is it that it's hard to start when it's warm outside or when the engine and ambient temperature are warm?Comment
-
As I recall the carb is right next to the distributorOriginally posted by Manisoba View Post
Comment
-
Problems with Pipepro 350
The Pipepro 350 is diesel, With a Mitsubishi engine, So I'm clear sorry about that !
It's doing it when the engine is already hot And using it during the day .
You guys any idea I'm stumped !Comment
-
Originally posted by Paul S View Post
Engine controller is damaged, Take it into your local Miller repair shop and have them change it out.Comment
-
Gentleman diesels are injected there is no carb and no distributor.Comment
-
Q
Sure there is. Just to the left of the aerial bearing and just above the drongle retroflector! (I'm sure that post was meant as humour as was this one!)Originally posted by owner-operator View Post
Tim
Many cordless tools...........
2 cordless hammers
2 cordless punches
1 cordless chisel
2 cordless screwdrivers, 1 + and 1 -
and a cordless adjustable wrench that also doubles as a hammer.....Comment
-
Problems with Pipepro 350
Cruizer is this a on going problem with the Pipepro , have you heard of anyone else with the same problem ?
Thanks for the input !!Comment
-
A friend of mine had the same problem and fix. Works great.
Do you adjust the carb with a metric crescent wrench also. LolSyncrowave 250
Millermatic 210
dialarc 250
spectrum 375x
trailblazer 302
Lincoln 135Comment
-
Yes quite common, and for the idiot non diesel guys its best to lean out and rejet the carb, and change out the spark plugsOriginally posted by Paul S View PostComment
-
Problems with Pipepro 350
Only one guy not guys. I'm well aware this is no carb hence why I asked where one would find itComment
-
Problems with Pipepro 350
Hey Cruizer where is that engine controller at I don't see it in the manual and is it expensive ?
Thanks for the input I appreciate it!Comment
-
Left side under the blue sheet metal and pretty much dead center in the white box.
Your machine would have to be still under warranty, sooooo, free.Comment
-
Problems with Pipepro 350
Hey Cruizer called and talked to a miller tec he said there was a bad batch of them .
He's putting one in the mail for me be here in two days !
Again thank you !Comment
Comment