No announcement yet.

Dynasty 200-DX hand control issue

This topic is closed.
  • Filter
  • Time
  • Show
Clear All
new posts

  • #46
    I suspect the OP is going to have trouble with ANY fingertip control, since it's hard to weld with a sprained shoulder, from patting oneself on the back.

    He may be "the next coming when it comes to electrical engineering", but he doesn't know jack about tig welding and the controls used to accomplish specific tasks. Also, if he paid $4,600 for his machine, he hasn't figured out how to "strike the best deal". Maybe he's a little "butt hurt" about that.

    If he'd spent an hour on the forum BEFORE HE PURCHASED HIS MACHINE, he'd have known better what to order. Instead, he chose to order his machine and then condemn Miller for selling him something that didn't perform as he expected.

    As I said before, there is NO single remote control that does every task BEST. I have the foot pedal, the fingertip amp controller, and a on/off button, and use the one that best serves the task at hand.
    Syncrowave 250 DX Tigrunner
    Dynasty 200 DX
    Miller XMT 304 w/714D Feeder & Optima Control
    Miller MM 251 w/Q300 & 30A SG
    Hobart HH187
    Dialarc 250 AC/DC
    Hypertherm PM 600 & 1250
    Wilton 7"x12" bandsaw
    PC Dry Cut Saw, Dewalt Chop Saw
    Milwaukee 8" Metal Cut Saw, Milwaukee Portaband.
    Thermco and Smith (2) Gas Mixers
    More grinders than hands


    • #47
      I think all that needed to be said on this topic has been covered.