No announcement yet.

DeWalt grinder flange nut

  • Filter
  • Time
  • Show
Clear All
new posts

  • DeWalt grinder flange nut

    I finally got a Dewalt 5/6" grinder D28065 (used). Have always used Makita until now. Grinder came with a buffing wheel mounted, hence no backing flange and/or nut. Where is the best place to buy, say, a 5 pack of each, cause they are sure to get lost over time. I have about a dozen flanges and nuts for Makita grinders, but of course they do not fit the Dewalt.

  • #2
    Amazon may carry them in bulk, just do a search. DeWalt offers a retailer finder on their site below. This might not be the set you are looking for, but the site should have yours if not. Here in a town of 30,000 there are a number of industrial supply stores that carry them in stock...grab your Yellow Pages.
    Miller 251...sold the spoolgun to DiverBill.
    Miller DialArc 250
    Lincoln PrecisionTig 275
    Hypertherm 900 plasma cutter
    Bridgeport "J" head mill...tooled up
    Jet 14 X 40 lathe...ditto
    South Bend 9" lathe...yeah, got the change gears too
    Logan 7" shaper
    Ellis 3000 band saw
    Hossfeld bender w/shopbuilt hyd.
    Victor Journeyman torch and gauges
    3 Gerstner boxes of mostly Starrett tools
    Lots of dust bunnies
    Too small of a shop at 40 X 59.