Announcement

Collapse
No announcement yet.

Minor electric shock when welding.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • WillieB
    replied
    A welder uses a circuit where nothing is literally grounded. The power company's supply circuit in the case of residential power sources has the center tap in the transformer "GROUNDED". Your welder primary does not use the centertap. It is incidentally properly connected to center tap at one point in the building. Your secondary circuit in the welder is not "GROUNDED" sadly, that leaves the door open to unintentional potential. Your workpiece rests on earth, or has indirect contact. You are standing on earth, or have indirect contact. A potential (voltage) might exist between you, and your stinger, or gun.

    Strive to not be in the path. Wear gloves, boots. Don't weld with bare skin exposed. When extremely sweaty, don't rest against the workpiece with your back.

    In the case of HF (TIG stabilizing current) all bets are off. HF current can travel inches through ionized air to zap you. Always provide an easier path for electricity.

    Leave a comment:


  • Vintage Racer
    replied
    FWIW, try to not make the ground "hunt" for a path, back when I built anodized boat structures it was common for me to use an extra ground lead from the table to another place on the weldment to prevent getting zapped when the structure was mocked up for tacking.

    Leave a comment:


  • Zulmanny
    replied
    Thank you. Bob, the gooseneck is fine no cracks, the weather until this week in Miami was very dry.
    Mac702, the weldments are new so it may be the position of the clamp.

    Leave a comment:


  • aametalmaster
    replied
    Originally posted by Zulmanny View Post
    try to change the subject to no avail.
    Fixed you up buddy...Bob

    Leave a comment:


  • Zulmanny
    replied
    AAMETALMASTER: I thank you for your response, we appreciate it. Thanks
    MAC702: Thank you for letting me know that I made a mistake, what you said make sense and will make it easier for everyone. This is my first time posting on anything. My apologies, thanks.
    Ps;​​​ try to change the subject to no avail.
    Last edited by Zulmanny; 06-07-2017, 07:20 PM.

    Leave a comment:


  • MAC702
    replied
    When asking about the the possibilities of your equipment, pictures are worth a thousand words. Other causes can be the location of the work clamp and weldor on large weldments.

    Please use the subject line for the actual subject, so that we can search threads easily and remember what they are about when they turn up. Please use the advanced edit feature and change yours. All threads here can be "help me please" if you see my point.

    Leave a comment:


  • aametalmaster
    replied
    It happens to me on high humid days esp if I am sweating. Is the covering on the gun gooseneck broken or cracked?...Bob

    Leave a comment:


  • Zulmanny
    started a topic Minor electric shock when welding.

    Minor electric shock when welding.

    Good afternoon , if any one can help me, I will be very grateful, my welder advised me that when he starts welding some times he gets a minor electric shock.
    Can this be the M25 gun assembly?
    Millermatic 250X

    Last edited by aametalmaster; 06-07-2017, 08:38 PM.
Working...
X